Configure WiFi and QoS Settings
183
ProSAFE Wireless Controller
5. Click the tab for the radio for which you want to configure the WiFi settings.
6. Select the Turn Radio On check box.
The WiFi settings become accessible and you can configure them. If you cannot select
the Turn Radio On check box, see the requirements are the beginning of this section.
7. Configure the settings as described in the following table.
Setting Description
MU MIMO
(WAC740 access point and
802.11na/ac only)
Select the MU MIMO check box to enable multi-user MIMO
(MU-MIMO).
By default, the MU MIMO check box is cleared and MU-MIMO is
disabled.
802.11ac Wave 2 supports MU-MIMO, which enables multiple users to
receive data from the access point simultaneously using the same
channel. With MU-MIMO, an access point such as the WAC740, which
is capable of 802.11ac Wave 2, can transmit to multiple clients
simultaneously using the same channel. MU-MIMO is used in the
downstream direction and requires both the access point and the WiFi
clients to be capable of 802.11ac Wave 2.
To Next Page
Loading...
Need help?
General
