Configure WiFi and QoS Settings
206
ProSAFE Wireless Controller
6. Configure the settings as described in the following table.
7. In the table with WAC740 access points, select the check box for the WAC740 access point
that must monitor AirQual for the profile group.
If no WAC740 access point is assigned to the profile group, you cannot monitor AirQual
for the profile group.
8. Make sure that the selection from the Enable/Disable menu is Enable.
This option makes it possible to change AirQual monitoring from one WAC740 access
point in the profile group to another one. That is, if more than one WAC740 access point
is assigned to the profile group, you could disable AirQual for one WAC access point and
enable it on another WAC740 access point without the need to disable the AirQual
feature entirely.
The only available selection from the Mode menu is Dedicated.
Dedicated mode means that the WAC740 access point is dedicated to AirQual monitoring
and does not accept WiFi client associations.
9. Click the Apply button.
Your settings are saved.
For information about monitoring AirQual, see View AirQual for the Channels in a Profile
Group on page 346.
Setting Description
Enable/Disable Select the Enable/Disable check box to enable AirQual.
By default, the Enable/Disable check box is cleared and AirQual is
disabled.
Note: If you enable AirQual in a WiFi network that does not include
WAC740 access points, AirQual does not take effect.
Channel Quality Threshold Move the Channel Quality Threshold slider to the threshold position
or enter a number from 1 to 100 in the associated field. If the channel
quality exceeds the threshold, the wireless controller generates an
alert.
By default, the threshold position is 0, which effectively disables the
channel quality feature.
Channel Utilization Threshold Move the Channel Utilization Threshold slider to the threshold
position or enter a number from 1 to 100 in the associated field. If the
channel utilization exceeds the threshold, the wireless controller
generates an alert.
By default, the threshold position is 0, which effectively disables the
channel utilization feature.
To Next Page
Loading...
Need help?
General
