NETGEAR ProSAFE WC7500 User Manual

Maintain the Wireless Controller and Access Points
261
ProSAFE Wireless Controller
Note: Do not reboot the wireless controller while an extended storage device
is connected. Doing so causes the wireless controller to halt in the
boot process. First, disconnect the extended storage device. Then,
reboot the wireless controller.
 To mount an extended storage device and view information about the device or to
unmount an extended storage device:
1. Open a web browser, and in the browser’s address field, type the wireless controller’s IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller’s login window opens.
2. Enter your user name and password.
3. Click the Login button.
The wireless controller’s web management interface opens and displays the Summary
page.
4. Select Maintenance > Extended Storage.
5. Mount or unmount the extended storage device:
• To mount the extended storage device, do the following:
a. Attach the extended storage device to the USB port or SD card slot on the front
panel of the wireless controller.
Note: The SD card slot is available in only the WC7500 and WC7600v2
controllers.
b. Click the Refresh button.
c. Select the device to be mounted.
d. Click the Mount button.

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English