NETGEAR ProSAFE WC7500 User Manual

Manage Stacking and Redundancy
295
ProSAFE Wireless Controller
8. Configure the VRRP ID and local IP address of the primary controller (that is, the master) as
described in the following table.
These settings are required so that the primary controller and redundant controller can
establish a redundancy group.
The following table also includes descriptions of the nonconfigurable fields.
Setting Description
Controller Role This is a nonconfigurable field that shows that the role of the primary controller.
In a 1:1 redundancy configuration, by default, the role is master.
Controller IP This is a nonconfigurable field that shows the IP address of the primary
controller. This IP address is the address that you use to log in to the primary
controller’s web management interface.
Note: The controller IP address of the primary controller (the master) is also the
master IP address.
VRRP ID [1-255] For the primary controller, enter a number from 1 through 255 as the VRRP ID.
This number must be unique and not assigned to any other device in the
network.
Local IP For the primary controller, enter a local IP address. If a failover occurs, this IP
address remains assigned to the primary controller and does not transfer to the
redundant controller to let you identify the primary controller before and after
the failover. You must enter an IP address that is not assigned to any other
device.

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English