NETGEAR ProSAFE WC7500 User Manual

Monitor the WiFi Network and Its Components
334
ProSAFE Wireless Controller
The following table describes the fields of the Clients page.
Item Description
Select The radio button that lets you select the client.
MAC The MAC address of the WiFi client.
IP The IP address of the WiFi client.
Note the following:
• If clients and the access point to which they are connected are in the same
VLAN, all receive an IP address from the same DHCP server.
• If clients and the access point to which they are connected are not in the
same VLAN, you must provide a DHCP server for the client VLAN.
• If clients are not connected to any DHCP server, IP addresses in the
169.254.x.x. range are assigned automatically.
Location The location of the access point (see Change Access Point Information on the
Managed AP List on page 170) to which the WiFi client is connected.
AP-Name The name of the access point (see Change Access Point Information on the
Managed AP List on page 170) to which the WiFi client is connected.
AP-IP The IP address of the access point to which the WiFi client is connected.
AP-MAC The MAC address of the access point to which the WiFi client is connected.
Client Type The wireless mode that the WiFi client is using to connect to the access point
(802.11ng, 802.11bg, 802.11b, 802.11ac, 802.11na, or 802.11a).

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English