NF BP4610 - Store;Recall Memory

5.3 Explanation of Each Program Message
BP4610
5-16
 ARBN/ARBN?
Description: Specifies the memory number to be transferred and the memory number to
be cleared.
Parameter: 2 to 17
Setting example: Specifying arbitrary waveform memory 6
ARBN 6
Caution: An error occurs if 0, 1 is set to the parameter.
Note that since a waveform can also be specified during output, output is
performed even during arbitrary waveform rewrite.
 ARBT/ARBT?
Description: Transmits/receives arbitrary waveform.
Parameter: #42048
Data is in the 2’s complement format (1024 words, 2048 bytes)
Setting example: 1) ARBT #42048
2) [higher byte of data 0][lower byte of data 0][higher byte of data
1][lower byte of data 1]……[lower byte of data 1023]
Refer to “5.6 Programming Cautions”.
5.3.6 Store/recall memory
 *RCL
Description: Reads the settings.
Parameter: 1 to 30
Setting example: Reading the contents of store/recall memory 5
*RCL 5
Caution: This operation cannot be performed during output on.
 *SAV
Description: Saves the settings.
Parameter: 1 to 30
Setting example: Saving settings to store/recall memory 5
*SAV 5