6.1 Error Messages
BP4610
6-4
6.1.3 Errors during operation
Table 6-3 lists error messages that are displayed when errors occur during operation.
Error messages are displayed in the message box. The message box automatically closes 1.5 seconds
later.
Table 6-3. Errors during Operation
Error Message Error Description
INVALID WITH OUTPUT ON Setting (execution) is not possible while output is on.
INVALID WITH OUTPUT OFF Setting (execution) is not possible while output is off.
INVALID IN THIS MODE Setting (execution) is not possible because the mode is incorrect.
INVALID WITH THIS WAVE Setting (execution) is not possible with this waveform.
UNDER BUSY STATE Setting (execution) is not possible because of busy status.
UNDER REMOTE STATE Setting (execution) is not possible because of remote status.
UNDER LOCAL STATE Setting (execution) is not possible because of local status.
UNDER LOCAL LOCK OUT Setting (execution) is not possible because of local lockout.
UNDER KEYLOCK Setting (execution) is not possible because of keylock.
OUT OF LIMITER Output cannot be switched on because of over-limiter.
OUT OF RANGE USB parameter range check error
EXECUTION ERROR Execution error other than above
OUT OF MEASURE RANGE Measurement out of range
COMMAND ERROR USB interface command error
QUERY ERROR USB interface query error
Figure 6-2. Examples of Error Display During Operation
To Next Page
Loading...