9.1 Initial Setting List
BP4610
9-3
Table 9-4. Sequence Memory (All Steps)
Setting Item Initial Value At Shipping At Power-on After Reset
Step number specification 1 √ √ −
Step time 0.1000 s √ Backup value √
DC voltage 0.00 V √ Backup value √
DC current 0.000 A √ Backup value √
DC voltage/current operation type CONST √ Backup value √
Superimposed AC voltage 0.0 Vp-p √ Backup value √
Superimposed AC current 0.00 Ap-p √ Backup value √
Superimposed AC voltage/ current
operation type
CONST
√ Backup value √
Frequency 50.0 Hz √ Backup value √
Frequency operation type CONST √ Backup value √
Waveform SIN √ Backup value √
Waveform operation type CONST √ Backup value √
Step sync output 0, 0 √ Backup value √
Step sync output operation type CONST √ Backup value √
Step end phase DISABLE √ Backup value √
Step termination STOP √ Backup value √
Jump step 0 √ Backup value √
Jump count 1 √ Backup value √
Branch step 0 0 (invalid) √ Backup value √
Branch step 1 0 (invalid) √ Backup value √
To Next Page