NF BP4610 - 2.1 Before Using the BP4610

2.1 Before Using the BP4610
BP4610
2-1
！
2.1 Before Using the BP4610
Before setting up and using the BP4610, make sure that it has not suffered damage during transportation
and that all the accessories and the main unit are included. If anything is missing, contact the NF
distributor from which the product was purchased.
 Safety check
Before using the BP4610, read the INSTRUCTIONS FOR SAFE USE at the beginning of this
instruction manual and perform a safety check.
Also, before connecting the BP4610 to a power supply, read 2.2 Installation Environment and
thoroughly ensure that the installation environment is safe.
 Appearance and accessories check
First, check that the BP4610 has not been damaged during transportation. Before installating the
BP4610, check the product configuration, which is listed in Table 2-1 Configuration List.
Table 2-1. Configuration List
Item Q’ty
Main unit 1
Instruction Manual (this document) 1
Power cord set (125 V, 15 A) 1
When repacking the product for shipping, place it in a box of sufficient strength and size to safely
accommodate the weight and size of the product, making sure that the product is well protected.
This product contains high-voltage parts. Absolutely never remove its cover.
All internal inspections of this product are to be performed only by service technicians well trained in
hazard control.
The power cord set for use in Japan provided with this product is designed for use with this product only.
Do not use it for other products or applications.
WARNING
！
CAUTION