8.13 USB Interface
BP4610
8-9
Enabled or disabled (Status output is always on.)
Control input
Input level: High level: +4.0 V or higher
Low level: +1.0 V or lower
Non-destructive max. input: +10 V/−5 V
Input impedance: Pulled up to +5 V with 47 kΩ
Control items
Output OFF: Output off at fall
Output ON: Output on at fall
Sequence start: Sequence start at fall
Sequence stop: Sequence stop at fall
Hold input: Hold at fall
Branch input 0, 1: Branch start at fall
Status output
Output level: 0/+5 V (open)
Output impedance: 100 Ω
Status items
Power on/off status: 0-OFF, 1-ON
Output on/off status: 0-OFF, 1-ON
Overload: 0-Normal, 1-Overload
Software busy: 0-Normal, 1-Busy
Sequence operation step sync output 0, 1
Terminal
D-sub 25-pin multiconnector (rear panel)
8.13 USB Interface
A USB interface is provided for performing control from an external computer.
Interface standard: USB 1.1
USB ID: 1 to 65534
To Next Page
Loading...