9.1 Initial Setting List
BP4610
9-1
9.1 Initial Setting List
“√” indicates the fact that the initial setting is applied. “-” indicates that the setting until now is
maintained.
Table 9-1. Setting Memory
(1/2)
Setting Item Initial Value At Shipping At Power-on After Reset
Operation mode CV-INT √ Backup value √
Output OFF √
Depends on output
on/off setting at
power-on
(Reset is possible
only when output is
off)
Response calibrator OFF √
Depends on
response calibrator
on/off setting at
power-on
−
DC voltage 0.00 V √ Backup value √
DC current 0.000 A √ Backup value √
Superimposed AC voltage 0.0 Vp-p √ Backup value √
Superimposed AC current 0.00 Ap-p √ Backup value √
Frequency 50.0 Hz √ Backup value √
Waveform SIN √ Backup value √
+ voltage limiter 62.0 V √ Backup value √
− voltage limiter −62.0 V √ Backup value √
+ current limiter 26.0 A √ Backup value √
− current limiter −26.0 A √ Backup value √
USB ID 2 √ Backup value −
Keylock OFF √ Backup value −
Beep ON √ Backup value −
LCD contrast 55 √ Backup value −
LCD display color BLUE √ Backup value −
Frequency unit Hz √ Backup value −
Time unit s √ Backup value −
Output on/off at power-on OFF √ Backup value −
Response calibrator on/off at power-
on
OFF
√ Backup value −
External control input enable/disable DISABLE √ Backup value −
Arbitrary waveform transmit/receive,
control memory specification
2 (ARB1)
√ √ −
SRQ enable register 179 √ √ −
To Next Page