NF BP4610 - 8.7 Sequence Function

8.7 Sequence Function
BP4610
8-7
8.7 Sequence Function
The output parameters can be rapidly changed sequentially or swept.
The signal source is limited to internal signal or internal signal + external signal input.
The sequence function settings are saved to battery backed up memory.
Number of sequences: 1 sequence for each of the CV mode and CC mode
Number of steps: 1 to 255 (within 1 sequence)
Step time: 0.1 ms to 999.9999 s (0.1 ms resolution)
Operation within step: Constant or linear sweep
Parameters
CV mode: DC voltage, superimposed AC voltage, frequency, waveform Step
sync output, 2 bits
CC mode: DC current, superimposed AC current, frequency, waveform Step
sync output, 2 bits
Remark: If a sine wave or square wave is selected as the waveform, the
waveform cannot be changed during the sequence.
If arbitrary waveform is selected, an arbitrary wave can be specified
for each step.
Jump count: 1 to 999, or continuous
Sequence control
Start: Starts sequence.
Stop: Stops sequence.
Hold: Maintains settings at that point in time. The operation resumes at
sequence start.
Branch: Branches to the specified step.
8.8 Arbitrary Waveform Memory
The arbitrary waveform memory is memory for the superimposed AC of the internal signal
source. It is battery backed up.
Number of waveform memories: 16
Waveform length: 1024 words
Waveform data: 16 bits
Remark: Write to arbitrary waveform memory from the operation
panel is not possible. Write is performed via the USB
interface.