NF BP4610 - Table 9-2. Store;Recall Memory (All Memories); Table 9-3. Arbitrary Waveform Memory

9.1 Initial Setting List
BP4610
9-2
(2/2)
Setting Item Initial Value At Shipping At Power-on After Reset
Standard event status enable register 255 √ √ −
Operation transition filter 0 √ √ −
Operation event enable register 20482 √ √ −
Warning event enable register 1 √ √ −
Overload transition filter 0 √ √ −
Overload event enable register 1 √ √ −
Header on/off OFF √ √ −
Table 9-2. Store/Recall Memory (All Memories)
Setting Item Initial Value At Shipping At Power-on After Clearing
Operation mode CV-INT √ Backup value √
DC voltage 0.00 V √ Backup value √
DC current 0.000 A √ Backup value √
Superimposed AC voltage 0.0 Vp-p √ Backup value √
Superimposed AC current 0.00 Ap-p √ Backup value √
Frequency 50.0 Hz √ Backup value √
Waveform SIN √ Backup value √
+ voltage limiter 62.0 V √ Backup value √
− voltage limiter −62.0 V √ Backup value √
+ current limiter 26.0 A √ Backup value √
− current limiter −26.0 A √ Backup value √
Table 9-3. Arbitrary Waveform Memory
Setting Item Initial Value At Shipping At Power-on After Clearing
ARB1 to ARB8 Sine wave data √ Backup value √
ARB9 to ARB12
Square wave
dt
√ Backup value √
ARB13 to ARB16 Triangular wave √ Backup value √