NF BP4610 - Page 96

To Next Page

To Previous Page

4.5 Sequence Operation

BP4610

4-46

<10> Press the and keys to move the cursor to [STEP].

<11> Press the

ENTER

key to display the Modify box.

<12> Press the

and keys to move the cursor to the right-most digit, and then turn the

[MODIFY] dial to set “2”.

<13> Press the

ENTER

key to apply the set value.

<14> Press the

key to move the cursor to [TIME].

<15> Press the

ENTER

key to display the Modify box.

<16> Press the

and keys to move the cursor to the fourth digit from the right and then turn

the [MODIFY] dial to set “2” (thus setting 0.2 s).

<17> Press the

ENTER

key to apply the set value.

<18> Using the same operation as in steps <2> to <5>, set DC VOLT = 2.5, and using the same

operation as in steps <6> to <9>, set the DC voltage operation type to “KEEP”.

Then go on to set Step 3 and subsequent steps using the same procedure.