Oce 9600 - Work on a Remote System

The Océ 9600 applications 127
Work on a remote system
You can start up the Océ 9600 applications (Settings editor, Queue manager,
System control panel) except for Scan manager, on a remote client after you
installed the software (see chapter 8, ‘Remote Logic’ on page 113). In order to
use the functions, you first have to add an Océ 9600 controller and then connect
to an available Océ 9600 controller.
▼
▼▼
▼
Add an Océ 9600 controller
1
Open the ‘File’ menu and select ‘Connect to’.
A dialog box will appear with a drop-down list box containing the already
added Océ 9600 systems.
2
Click ‘Edit...’. The ‘Edit systems’ dialog box appears.
3
Enter the IP address of the Océ 9600 system you want to connect to, in the
‘Systems’ text box.
4
Click ‘Add’. The Océ 9600 is added to the list. You can add more systems.
Note:
You can remove an Océ 9600 system. Select one from the list and click
‘Remove’.
5
Click OK twice to return to the application.
Note:
Before you can add an Océ 9600 system, the system has to be installed
and configured by a system consultant or a technician.
▼
▼▼
▼
Connect to an Océ 9600 controller
1
Open the ‘File’ menu and select ‘Connect to’.
A dialog box will appear containing a drop-down list box with the available
Océ 9600 systems.
2
Select one of the available Océ 9600 systems and click on ‘OK’. When you
connect to another system, all settings have to be retrieved. This may take some
time.
Note:
You will have to perform the Add and Connect actions in the remotely
used Océ 9600 programs separately.