Oce 9600 - Special media indication; Interrupt a print job

34 Océ 9600 Copier/Printer User Manual
Special media indication
On the Océ 9600 Printer, you can attach a Special indication (exclamation
mark: !) to a roll or cassette tray which uses special media (for instance colored
paper). This indication is used to identify the roll or cassette tray to the printer.
For this roll or cassette tray, the automatic media change option is disabled.
▼
▼▼
▼
Set a special media indication
1
Press the on line button on the printer operating panel to put the printer off line.
The ‘Off line’ message is displayed in the status window (see figure 10 on
page 32).
2
Press the left selection button to shift the focus to the Media option.
A shadow effect is used to indicate that the focus is set to this option.
3
Use the up/down buttons to select the roll or cassette tray for which you have
just loaded special media.
4
Press the right selection button to activate the ‘Type’ option.
The dotted line around the current selection is changed into an uninterrupted
line and the small selection triangles next to the specified type are no longer
dimmed.
5
Use the up/down buttons to select the Special option for the specified roll or
cassette tray.
6
Press the on line button to put the printer on line again. The printer now knows
that the specified roll or cassette tray contains special material.
Interrupt a print job
The red ‘Stop’ button on the Océ 9600 Printer operating panel interrupts the
active print process. You can cancel or continue the current print job.
▼
▼▼
▼
Cancel a print job
1
Press the ‘Stop’ button.
A dialog is displayed informing you that you can press ‘on line’ to continue or
stop to cancel the job.
2
Press the ‘Stop’ button again to cancel the current job.
Note:
In general, the printer cannot be stopped immediately because the
started prints have to be finished. Printing will be stopped at the end of the
page.
▼
▼▼
▼
Continue a print job
1
Press the ‘Stop’ button.