Oce 9600 - The scan width

Performing special copy jobs 59
The scan width
To prevent information loss when copying a non-standard original, you can
select the ‘non-standard’ scan width. The scanned width will then be larger
than the original width. It is also possible to define the scanned width and
length yourself.
▼
▼▼
▼
Defining the scan width
1
Open the ‘Sheet’ card in the ‘Original’ section.
2
Press ‘Scan width’ to select the required setting:
■
Standard. This option must be used to copy a standard-sized original.
■
Non-standard. This option can be used to copy a non-standard original. The
scanned width will be larger than the original width (to the next larger,
standard size), to prevent information loss.
■
Numeric. You can define the scan width yourself, using the higher/lower
buttons or the numeric buttons.
[24] Selecting ‘Non-standard’ scan size