Introduction 19
▼
▼▼
▼
Use the manual feeder
1
Select the manual feed option from the printer driver and select the media to
print on before you send the job to the printer.
Note:
More information about Océ 9600 Plot Director and other printer
drivers can be found in the online help provided with those drivers.
2
Wait until the following message appears on the printer display:
(for example):
Waiting for manual feed job xxx. Feed A3 portrait, plain paper
.
3
Go to the printer and specify the required media on the operating panel. See
‘Set media type for manual feeder’ on page 33 for more information.
4
Take your sheet of print material to the manual feed.
Note:
Avoid using sheets that have already been printed on one side.
Otherwise, the Océ 9600 might become damaged.
5
Use both hands to align the print material with the format indication on the
manual feed.
6
Move the material forward into the manual feed slot until the printer pulls in
the first part of the sheet.
A few seconds later, the complete sheet will be pulled into the printer.
7
If the print job requires more sheets, the printer will ask you to feed in the next
sheet.
8
Collect your output.
Note:
The sheet must be inserted face-up.
Océ 9600 controller
The Océ 9600 is equipped with a workstation which helps you to make
optimum use of your system. This workstation runs a number of applications
which allow you to control your print jobs, make your default printer settings
and monitor the printer status. These applications include:
■
Queue Manager (QM)
■
System Control Panel (SCP)
■
Settings Editor (SE)
■
Scan Manager (SM)
To Next Page
Loading...
