Using the Océ 9600 Copier 41
Display
The display is used to make settings for copying. The display provides
feedback about the system status.
The scanner display informs you about:
■
the number of copies you have selected, the media selection, input mode,
zoom settings and exposure.
■
the actual system status, for example ‘Ready to copy’. In the event of an error
in the scanner, the exact error location is graphically shown on the scanner
display, together with instructions on how to solve the problem.
Buttons
With the buttons on the operating panel you can make a number of settings for
the Océ 9600 Copier.
The following buttons are available:
Button type
Function
Start buttons
The green button marked with is used to start the
feeding of the original, or to re-start the copy process.
Numeric buttons
The buttons with numbers on the lower part of the oper-
ating panel are used to enter numbers.
Correction button
The orange button marked with C, located at the bottom
right of the operating panel. If you press the correction
button once, the copy counter is set to the default (prob-
ably ‘1’). If you press this button twice, all settings are
reset to their default values.
Stop button
Pressing the red button to the left of the display stops the
copy process for the current original. You can stop the
original transport immediately when an original jam oc-
curs.
Interrupt button
Currently not in use.
To Next Page
Loading...
