Oce 9600 - Make key operator settings in the Settings Editor

Key operator settings 139
Key operator settings
In order to perform special key operator functions, you must log on to the
Settings Editor as a key operator.
Because these functions are restricted to a dedicated key operator, a password
is required to access them. The service engineer will provide this password to
you upon installation.
Note:
When you are finished, make certain you log out of the Key operator
mode of the Settings Editor to prevent unauthorized use of the Océ 9600.
▼
▼▼
▼
Make key operator settings in the Settings Editor
1
Maximize the Settings Editor on the screen.
2
Log in as key operator.
3
Click on one of the top buttons to display the desired group of settings.
4
Select the setting you want to update in the tree structure.
5
Update the setting in the update area, as required.
Note:
A few settings, such as the defaults for the Custom card, are made
directly from the tree structure area.
6
Click on the ‘Apply’ button.
The new value is now applied for the setting
7
Log out of the Key operator mode when you have finished updating the
settings.