272 Océ 9600 Copier/Printer User Manual
Off line folding
An important productivity feature provided by the Océ 9600 folder, is the
possibility to make off line folds. For off line folding the same settings can be
made as for normal folding. By default, the predefined settings in the Settings
Editor for off line folding are used. Polyester or transparent media cannot be
folded. This may result in a media jam.
Note:
Use off line folding only for sheets which do not exceed a maximum
length of 6 m. If you try to fold a sheet longer than 6 m anyway, an error occurs.
▼
▼▼
▼
Make off line folds
1
Switch the printer off line on the printer operating panel and wait for the printer
to finish the jobs that are already in the printer.
Note:
Watch the light on the top cover of the folder.
■
If this is off, the printer is on line and off line folding is not possible.
■
If this is blinking slowly, the printer is off line, but the folder is still
processing the last prints.
■
If this is blinking rapidly, an error has occurred.
■
If this is on, the printer is off line and you can feed in a sheet.
Note:
Also, refer to the sticker on the top cover of the folder.
2
Choose any settings for (off-line) folding on the printer operating panel.
Note:
If required, the key operator can change the default settings for
folding programs from the Settings Editor. See chapter 10, ‘Key operator
settings’ on page 129 for more information.
Off-line folding settings
Output length Delivery
‘Stacker’ or ‘Belt’
selected
=< 2.19 yd Delivered on stacker or belt
2 m - 2.5 m (2 folds) Delivered on stacker or belt
2 m - 2.5 m (3 folds) Stopped in second fold (possible
paper jam)
> 2.73 yd Unfolded, delivered in IRT
‘First fold only’ selected
< 6.56 yd First fold only, delivered in first
fold delivery
[169] Off-line folding settings
To Next Page
Loading...
