Oce 9600 - Reinforcement unit maintenance

232 Océ 9600 Copier/Printer User Manual
Reinforcement unit maintenance
This section covers maintenance activities for the optional folder
reinforcement unit, such as:
■
Inserting a new tape roll
■
Emptying the waste box
■
Cleaning the reinforcement knives
Attention:
Only use the original reinforcement strips from Océ, to avoid
damage to the reinforcement unit.
A new tape roll
When the tape roll is empty while the engine is on stand-by, one of these
messages will appear on the display:
■
‘Load reinforcement tape’
■
‘Reinforcement unit empty’ (if the engine was running when the roll ran out
of tape).
When a tape roll is empty while the engine is running, this message will be
accompanied by a picture of the engine with the side door of the reinforcement
unit blinking (see figure 115).
[115] No tape in reinforcement unit