182 Océ 9600 Copier/Printer User Manual
Sleep mode timer
Description
Use ‘Sleep mode timer’, to specify how many minutes of in-
activity are required before the Océ 9600 switches to Sleep
mode. In Sleep mode, most of the power supply is cut off.
Note: The sleep mode time out also applies to the scanner
and the folder, but NOT to the controller.
Min/max values
N/A
Menu path
System - Timers - Sleep mode timer - <value> - Apply
Manual feed time out
Description
Use ‘Manual feed time-out’, to define the manual feed
time-out in. This is done in terms of seconds. This time-out
is the amount of delay time that must pass before jobs will
get the ‘not ready to print’ status (e.g. when the sheet is not
being fed).
Min/max values
N/A
Menu path
System - Timers - Manual feed time out - <value> - Apply
Controller panel time out
Description
Use ‘Panel time-out’, to set the panel time-out for the scan-
ner panel. When no settings are being selected and no origi-
nal is being scanned, the panel will switch to the default
settings after this time out has elapsed. By default, this set-
ting is ‘ON’. The default panel time-out is 90 sec.
Min/max values
N/A
Menu path
System - Timers - Controller panel time out - <value> - Ap-
ply
To Next Page
Loading...
