Oce 9600 - Page 189

Key operator settings 189
Panel time out
Description
The ‘Panel time out’ option allows you to set the panel time
out of the scanner panel. When no settings are being made
and no original is being scanned the panel will switch to de-
fault settings after this time out has elapsed.
Min/max values
30 - 600 seconds
Menu path
Scanner - Settings - Timers - Panel time-out - <value> - Ap-
ply
Set time out
Description
The ‘Set time-out’ option allows you specify how much time
must elapse before the set on the scanner is automatically
closed if no new original is fed and the set is not closed with
the start key.
Min/max values
10 - 600 seconds
Menu path
Scanner - Settings - Timers - Panel time-out - <value> - Ap-
ply
Automatic feed time out
Description
If you enable the ‘Automatic feed time out’ option, you only
have to use the start key once at the beginning of the scan
job.
If this option is disabled, you will have to press the start key
for every original in order to start scanning or copying.
Min/max values
15 - 600 seconds
Menu path
Scanner - Settings - Timers - Automatic feed time out - <val-
ue> - Apply