Oce 9600 - Enable Automatic Language Sensing (ALS)

System administrator settings 199
Note:
If your plot is not recognized correctly, define the data format in a remote
control file or an Océ Job Ticket and then send the plot again. In that case, the
selected option only applies to this job.
You can also select the appropriate data format manually on the Settings
Editor panel and then resend the plot. However, this setting will remain active
for all incoming prints on that connection. This means that you will need to
reset machine default settings to Automatic in order to return to your “normal”
working mode.
For further information on remote control, refer to the Remote Control File
Reference Manual or the Océ Job Ticket Reference Manual.
▼
▼▼
▼
Enable Automatic Language Sensing (ALS)
1
Click on the ‘System’ button.
The System settings are displayed
2
Click on the ‘Connectivity’ folder.
A list of available connection types is displayed.
3
Click on the folder for the appropriate connection type.
4
Select the ‘PDL selection’ option.
5
Select ‘Automatic’ (the default value) to activate Automatic Language Sensing
6
Click on the ‘Apply’ button to save the changes you made.
Note:
The following default settings can be overruled by settings that are sent
along with the print or copy job: