Using the Océ 9600 Copier 45
with the Arrow buttons.) The ‘Original type’ setting demonstrated in figure
13 on page 43 is an example of this.
■
Numeric selection: activate the selection triangles and select the desired
value with the Arrow buttons or with the numeric buttons. The ‘Brightness’
setting demonstrated in figure 13 on page 43 is an example of this.
Also a combination of simple selection and numeric selection is possible, as
shown in the ‘Cut length’ setting demonstrated in figure 14 on page 44.
Note:
The Up arrow and Down arrow buttons can be used to increase or
decrease the active value by 1; the Left arrow and Right arrow buttons
increase or decrease the active value by 10. An exception to this rule is the
selection of zoom values. The Left arrow button can be used to browse
through the predefined reduction steps and the Right arrow button to
browse through the predefined enlargement steps.
To Next Page
Loading...
