Oce 9600 - Page 66

66 Océ 9600 Copier/Printer User Manual
▼
▼▼
▼
Manually adjust the exposure setting
1
Press the ‘Exposure’ function button and use the arrow buttons to set the
exposure as desired.
Note:
The Up and Down arrow buttons can be used to gradually increase
or decrease the exposure setting; the Left or Right arrow buttons can be
used to go to the highest or lowest available exposure level at once. If you
want to go from any negative value to the highest possible positive value or
vice versa, you have to press the corresponding Left or Right button twice.
2
Specify other settings as required.
3
Feed in the original.
The Océ 9600 Copier allows you to adjust the exposure setting according to
the type of image on the original. There are five original types available. Select
a suitable mode according to the original (see figure 32 on page 65).
▼
▼▼
▼
Adjust the brightness according the type of image
1
Press the ‘Original type’ function button to select the appropriate image type:
■
By default ‘Lines/text’ is selected with ‘Background compensation’ enabled.
This is the most suitable setting for originals that contain characters and line
art.
■
Press the ‘Original type’ function button to select ‘Photo’ when the original
consists of a combination of characters, line art and picture images.
Note:
If you select ‘Photo’ or ‘Grays&lines’ , the ‘Background
compensation’ will be disabled automatically by default.
■
Press the ‘Original type’ function button to select ‘Grays&lines’ when the
original contains many gray scales and lines.
■
Press the ‘Original type’ function button to select ‘Blue print’ when you want
to copy an original with an image in ‘negative’ (image in white on dark
background). The copy will be ‘positive’ (image in black on white
background).
■
Press the ‘Original type’ function button to select ‘Dark orig’ when the
original has an extremely dark background (i.e. low contrast).
2
Specify other settings as required.
3
Feed in the original.