APPLIED OPERATIONS/Image Acquisition
OPERATION INSTRUCTIONS
2-70
Page
z When observing a fluorescence image simultaneously, set the required channel ready
for acquisition of fluorescence image.
Make sure that the check box showing the dyeing method in the [Ch1]/
[Ch2]/[Ch3]/[Ch4] group box is check-marked to indicate that the corresponding
channel is ready for image acquisition.
z Set the brightness of the transmitted image.
Please use PMT, Offset and Gain LED sliders in [Ch5] group box to adjust the
brightness of the transmitted image. For details, see section 2-2-1-4-9, “Adjusting the
Image Brightness” in the [OPERATION] volume.
z When observing a fluorescence image(s) simultaneously, also set the brightness of the
fluorescence image(s).
Adjust the brightness of the image of the transmitted image acquisition channel(s) by
using the [PMT], [Offset] and [Gain] LED sliders in its group box in the [Acquire] panel.
For details, see section 2-2-1-4-9, “Adjusting the Image Brightness” in the
[OPERATION] volume.
Ch1 check box
Ch2 check box
Ch3 check box
Ch4 check box
To Next Page
Loading...
