CHAPTER 13 – Multilingual Features OMRON
Page 226 Release 2.0
Once configured, follow these steps to convert the application:
1. It can be worth checking the language configuration, by running the old application under
the old CX-Supervisor version and confirming all characters are correctly shown
2. Install the new CX-Supervisor version and load the old project.
3. Open each page and select “File menu|Save Page” to force the pages to be written in the new
Unicode format
4. Select “Project menu|Save” to force the project to be written in the new Unicode format and
then run the project to recompile the application
5. Test the application fully in all supported languages, and by entering text from different
Locales.
To Next Page
Loading...
