CHAPTER 2 – Pages OMRON
Page 20 Release 2.0
Saving a Page to a Project
Once a page has been created it is wise to save it into the project in which it is planned to reside. It is
good practice to ensure that pages are saved regularly, for example to minimise the loss of work in
the event of a power failure.
To save a page click the Save Page button from the toolbar. If this is the first time the page
has been saved, the Save As dialog is displayed. This is a standard Windows dialog and
usage depends on your operating system. Please consult your Microsoft documentation.
1, 2, 3…
1. Move to the location where the page file is to be stored.
2. Ensure that the Save as Type: control is set to CX-Supervisor Pages
(*.PAG).
3. Enter a name in the File Name: field.
4. Click the Save pushbutton to save the file.
Subsequent saves do not cause the Save As dialog to be displayed.
After clicking the Save pushbutton, if the page is currently not assigned to a project, a confirmation
dialog is displayed. Alternatively, select Save Page from the File menu (or use the short-cut key
combination of <Ctrl>+S.
Save Page As
Should a copy of a page be required, (for incorporation into another project perhaps), select Save
Page As... from the File menu.
CX-Supervisor displays the File Save As dialog as described previously. After entering a new name
for the page, CX-Supervisor prompts to save the different page into the current project as above.
Closing a Page
To close a page after editing select Close Page from the File menu.
Alternatively, either click on the control box for the page, (located in the top left corner of the page)
and select Close from the Control menu, or simply double-click on the Control menu and the page
closes.
Should you attempt to close a page which has not been saved, CX-Supervisor displays a confirmation
dialog. If you want to save the changes, click the Yes pushbutton. Otherwise, click the No
pushbutton, or click the Cancel pushbutton to abort closing the page.
CX-Supervisor Preferences
CX-Supervisor allows a user to customise the working environment. To set or amend the CX-
Supervisor setup, select Preferences from the File menu, followed by the preference to set up.
To Next Page
Loading...
Need help?
General