6-19
Function
Refer-
ence
page
Setting
range
DescriptionNameNo.
Operation
selection at
operation mode
switching (local/
remote switch-
ing)
n114 Operation
selection at
operation mode
switching (lo-
cal/remote
switching)
Select whether or not to ignore run signals
input while the operation mode is switched
using the Operation Mode Selection Key
on the Digital Operator or with operation
mode selection input from the multi-func-
tion inputs.
0: Run signals that are input during mode
switching are ignored. (Input run sig-
nals after switching the mode.)
1: Run signals become effective immedi-
ately after mode.
Note If
n1
14 is set to 1, when the operation
mode
changes the Inverter may start
running immediately. Take steps to
ensure safety for such operation.
0, 1
[0]
3-91
(Manufacturer’s
use)
n115,
n116
For the manufacturer’s use. (Do not set.) See
note
---
Note Setting ranges and default settings vary with the Inverter model.
Appendix Chapter 6
To Next Page
Loading...
Need help?
General