Omron XTRADRIVE

XtraDrive User Manual Table of Contents/Preface
xv
CAUTION
• Conduct trial operation on the servomotor alone with the motor shaft disconnected from
machine to avoid any unexpected accidents.
Not doing so may result in injury.
• Before starting operation with a machine connected, change the settings to match the
parameters of the machine.
Starting operation without matching the proper settings may cause the machine to run out of
control or malfunction.
• Before starting operation with a machine connected, make sure that an emergency stop
can be applied at any time.
Not doing so may result in injury.
• Do not touch the heat sinks during operation.
Not doing so may result in burns due to high temperatures.
 Maintenance and Inspection
WARNING
• Do not remove the panel cover while the power is ON.
Doing so carries a risk of electric shock.
• Do not touch terminals for five minutes after the power has been turned OFF.
Residual voltage may cause electric shock.
• Never touch the inside of the servo amplifier.
Doing so may result in electric shock.
CAUTION
• Do not disassemble the servomotor.
Doing so may result in electric shock or injury
• Do not attempt to change wiring while the power is ON.
Doing so may result in electric shock or injury