Note:
It is assumed that you have a working NIS or LDAP service on your network.
This chapter does not describe how to set up the NIS or LDAP service.
9.2 Verify the NIS Setting on Exalogic
To verify the NIS setting in your storage appliance, complete the following steps:
1. Log in to the Browser User Interface (BUI) of the storage appliance in your Exalogic
machine.
2.
Click Configuration > SERVICES > NIS. NIS Server configuration information is
displayed, as shown in Figure 9-1.
3.
Note down the domain name and the server IP address listed on the page. You
require this information when setting up NIS clients on Exalogic compute nodes. If
you do not see configuration information on this page, it means that you should
install an NIS Server. Figure 9-1 uses an example NIS domain
nisdomain.example.com.
Figure 9-1 NIS Service
9.3 Configure the Storage Appliance
You must configure two services in the storage appliance for using NFSv4 on Exalogic:
• Configure the NFS Service
• Configure the NIS Service
Verify the NIS Setting on Exalogic
9-2 Oracle Exalogic Elastic Cloud Machine Owner's Guide
To Next Page
Loading...
Need help?
General
