Figure 8-4 igb2 and igb3 in an IPMP Group
Note:
The interface names and IP addresses shown on the screens in this chapter are
examples only. You must verify the interface names in your environment and
use them accordingly.
In the Properties section, if you select the Allow Administration option, management
is enabled on the interface. To create an IPMP Group with two interfaces, such as
igb2 and igb3, you must click the + icon (next to Interfaces) on the Figure 8-2. The
Network Interface screen is displayed, as shown in Figure 8-5.
Configuration Overview
Configure the Storage Appliance 8-9
To Next Page
Loading...
