Figure 3-4 Location of Mounting Brackets on Rack
1.
Obtain four bolts and washers to mount the Exalogic machine to the floor. The bolt
holes in the mounting brackets have a 10.0 mm diameter. Oracle does not provide
mounting bolts because different floors require different bolt types and strengths.
2.
Position the Exalogic machine over the pre-drilled holes. Figure 3-5 shows the
bottom view of the Exalogic machine, and the location for the mounting hole and
floor cut dimensions.
Figure 3-5 Bottom View of Exalogic Machine Showing Mounting Hole and Floor
Cutout Dimensions
• 1: Distance from mounting bracket to the edge of the rack is 113 mm (4.45
inches)
Prepare to Install an Exalogic Machine
Install Planning and Procedure 3-9
To Next Page
Loading...
