3. Restart the rpcidmapd service:
service rpcidmapd restart
4. Update the /etc/yp.conf configuration file, and set the correct domain value, as
in the following example:
vi /etc/yp.conf
Add the following line:
domain us.myexample.com server <NIS_Server_hostname_or_IP>
Where us.myexample.com is the example domain and
<NIS_Server_hostname_or_IP> is the host name or IP address of the NIS server.
You must replace these sample values with values appropriate for your
environment.
5.
Set NIS domain name on the command line:
# domainname <NIS_DOMAIN_NAME>
For example:
# domainname nisdomain.example.com
6. Edit the /etc/nsswitch.conf configuration file:
vi /etc/nsswitch.conf
Change the following entries:
#passwd: files
passwd: files nis
#shadow: files
shadow: files nis
#group: files
group: files nis
automount: files nis nisplus
aliases: files nis nisplus
7. Restart the rpcidmapd service:
# service rpcidmapd restart
8. Restart the ypbind service by running the following command:
# service ypbind restart
9. Check the yp service by running this command:
# ypwhich
10.
Verify if you can access Oracle user accounts:
# ypcat passwd
11.
Add ypbind to your boot sequence, so that it starts automatically after rebooting.
# chkconfig ypbind on
Configure an Exalogic Linux Compute Node to Use NFSv4
Configure NFS Version 4 on Exalogic 9-5
To Next Page
Loading...
Need help?
General
