e101cn02# ipadm create-addr –T static –a local=10.100.44.68/22 bond1/v4
h. Verify that your bonded interface is up, by running the following command:
hostname# ipadm show-if
IFNAME CLASS STATE ACTIVE OVER
lo0 loopback ok yes --
net0 ip ok yes --
net4 ip ok yes --
net8 ip down no --
net9 ip down no --
bond0_0 ip ok yes --
bond0_1 ip ok no --
bond1 ipmp ok yes eoib1 eoib0
eoib1 ip ok no --
eoib0 ip ok yes --
i.
Verify that your bonded interface was given an IP address by running the
following command:
# ipadm show-addr
ADDROBJ TYPE STATE ADDR
lo0/v4 static ok 127.0.0.1/8
net0/v4 static ok 138.3.2.87/21
net4/v4 static ok 169.254.182.77/24
bond0/v4 static ok 192.168.14.101/24
bond1/v4 static ok 138.3.48.35/22
bond1/v4a static ok 138.3.51.1/22
lo0/v6 static ok ::1/128
net0/v6 addrconf ok fe80::221:28ff:fed7:e944/10
10.3.2 Set Up Ethernet Over InfiniBand on Oracle Solaris 11.2
To set up Ethernet over InfiniBand connectivity for Exalogic compute nodes running
Oracle Solaris 11.2 Base Image of EECS 2.0.6.2.0 perform the following procedure:
1. Use an SSH client, such as PuTTY, to log in to a compute node as root. For this
example log in to el01cn16 as root.
2. Run the following command to verify that the image version is EECS 2.0.6.2.0 or
greater, and the kernel version is SunOS 11.2.
root@el01cn16:~# imageinfo
A section of the output of this command is as follows:
Exalogic 2.0.6.2.0 (build:r240216)
Image version : 2.0.6.2.0
. . .
Kernel version : SunOS 11.2
. . .
3.
Get the names of the InfiniBand (IB) datalink by running the following command:
root@el01cn16:~# dladm show-phys
The following is a section of the output of the command that displays net4 and
net5 as the names for the IB datalink:
LINK MEDIA STATE SPEED DUPLEX DEVICE
. . .
Set Up Ethernet Over InfiniBand (EoIB) on Oracle Solaris
10-12 Oracle Exalogic Elastic Cloud Machine Owner's Guide
To Next Page
Loading...
Need help?
General
