root@el01cn16:~# ipadm set-ifprop -p standby=on -m ip vnic3066_1
root@el01cn16:~# ipmpstat -i
INTERFACE ACTIVE GROUP FLAGS LINK PROBE STATE
vnic3066_1 no bond1 is----- up disabled ok
vnic3066_0 yes bond1 --mbM-- up disabled ok
bond0_1 no bond0 is----- up disabled ok
bond0_0 yes bond0 --mbM-- up disabled ok
15. From the session to switch el01sw-ib03 run the following command to verify
that the active VNIC is up on the switch el01sw-ib03:
[root@el01sw-ib03 ~]# showvnics |grep cn16
105 UP N 0021280001EFF369 el01cn16 EL-C 192.168.10.16 31744
80:C0:A0:09:16:01 NO 0xffff 0A-ETH-1
106 UP H 0021280001EFF369 el01cn16 EL-C 192.168.10.16 64513
02:08:20:42:A1:F1 3066 0x8206 0A-ETH-1
16.
On the switch el01sw-ib02, the passive VNIC is not expected to appear until the
IPMP group failover process runs. From the session to the switch el01sw-ib02
run the following command to verify the state of the VNIC:
[root@el01sw-ib02 ~]# showvnics|grep cn16
108 UP N 0021280001EFF36A el01cn16 EL-C 192.168.10.16 31744
00:14:4F:09:16:02 NO 0xffff 0A-ETH-1
Set Up Ethernet Over InfiniBand (EoIB) on Oracle Solaris
10-16 Oracle Exalogic Elastic Cloud Machine Owner's Guide
To Next Page
Loading...
Need help?
General
