/scsi_vhci/disk@g600144f09c96cca90000518cdeb10005
1. c0t600144F09C96CCA90000518CDF100006d0 <SUN-ZFS Storage
7320-1.0-64.00GB>
/scsi_vhci/disk@g600144f09c96cca90000518cdf100006
2. c0t600144F09C96CCA90000518CDFB60007d0 <SUN-ZFS Storage
7320-1.0-64.00GB>
/scsi_vhci/disk@g600144f09c96cca90000518cdfb60007
3. c0t600144F09C96CCA900005190BFC4000Ad0 <SUN-ZFS Storage 7320-1.0 cyl
8352 alt 2 hd 255 sec 63>
/scsi_vhci/disk@g600144f09c96cca900005190bfc4000a
4. c7t0d0 <LSI-MR9261-8i-2.12-28.87GB>
/pci@0,0/pci8086,340a@3/pci1000,9263@0/sd@0,0
Specify disk (enter its number): Specify disk (enter its number):
The value after /scsi_vhci/disk@g is the GUID of the LUN you created in
Create the Project and LUN. In this example, the disk
c0t600144F09C96CCA900005190BFC4000Ad0 with the GUID
g600144f09c96cca900005190bfc4000a should be formatted and labelled.
5.
Format the disk by doing the following:
a.
Run the format command to start formatting the disk as follows:
# format -e c0t600144F09C96CCA900005190BFC4000Ad0
selecting c0t600144F09C96CCA900005190BFC4000Ad0
[disk formatted]
The format prompt appears.
b. Enter fdisk to manipulate the partition tables as follows:
format> fdisk
No fdisk table exists. The default partition for the disk is:
a 100% "SOLARIS System" partition
c. When prompted, enter n to edit the partition table.
Type "y" to accept the default partition, otherwise type "n" to edit the
partition table. n
d. Enter 1 to set the partition type.
e. Enter f to set the partition type as EFI (Protective) as follows:
Select the partition type to create:
1=SOLARIS2 2=UNIX 3=PCIXOS 4=Other 5=DOS12
6=DOS16 7=DOSEXT 8=DOSBIG 9=DOS16LBA A=x86 Boot
B=Diagnostic C=FAT32 D=FAT32LBA E=DOSEXTLBA F=EFI (Protective)
G=EFI_SYS 0=Exit? f
6.
Label the LUN by doing the following:
a.
Enter 6 to label the LUN.
The format prompt appears.
b.
Enter label to label the disk as follows:
format> label
The list of label types appears.
Create a Solaris Zone
F-6 Oracle Exalogic Elastic Cloud Machine Owner's Guide
To Next Page
Loading...
Need help?
General
