MaintenanceFP2/FP2SH
9 − 5
9.1 Replacement of Spare Parts
Procedure for FP2SH
1. Lift up the lead wire.
Make sure the lead wire next to the connector insertion
area, which is also the battery holder, is lifted out of the
hole that secures it in place.
2. Lift up the battery.
3. Pull the connector off.
Pull the connector straight off, so the terminals do not
bend.
4. Install the new battery by reversing the above proce-
dure.
Make sure the connector terminals are positioned in the
correct directions.
To Next Page
Loading...
