Panasonic fp2/fp2sh - Page 291

11-23
FP2/FP2SH/FP10SH
Address
Name
Description
R9050
MEWNET-W/-P link
transmission error flag
[W/P LINK 1]
When using MEWNET-W link unit or MEWNET-P link
unit:
- turns on when transmission error occurs at link 1.
- turns on when there is an error in the link area settings.
R9051
MEWNET-W/-P link
transmission error flag
[W/P LINK 2]
When using MEWNET-W link unit or MEWNET-P link
unit:
- turns on when transmission error occurs at link 2.
- turns on when there is an error in the link area settings.
R9052
MEWNET-W/-P link
transmission error flag
[W/P LINK 3]
When using MEWNET-W link unit or MEWNET-P link
unit:
- turns on when transmission error occurs at link 3.
- turns on when there is an error in the link area settings.
R9053
MEWNET-W/-P link
transmission error flag
[W/P LINK 4]
When using MEWNET-W link unit or MEWNET-P link
unit:
- turns on when transmission error occurs at link 4.
- turns on when there is an error in the link area settings.
R9054
MEWNET-W/-P link
transmission error flag
[W/P LINK 5]
When using MEWNET-W link unit or MEWNET-P link
unit:
- turns on when transmission error occurs at link 5.
- turns on when there is an error in the link area settings.
R9055 Not used
-
R9056
Not used
-
R9057 Not used
-
R9058
Remote I/O transmission
error flag (master 1)
When using MEWNET -F (remote I/O) system:
- turns on when transmission error occurs on master 1.
- turns on when there is an error in the settings.
R9059
Remote I/O transmission
error flag (master 2)
When using MEWNET -F (remote I/O) system:
- turns on when transmission error occurs on master 2.
- turns on when there is an error in the settings.
R905A
Remote I/O transmission
error flag (master 3)
When using MEWNET -F (remote I/O) system:
- turns on when transmission error occurs on master 3.
- turns on when there is an error in the settings.
R905B
Remote I/O transmission
error flag (master 4)
When using MEWNET -F (remote I/O) system:
- turns on when transmission error occurs on master 4.
- turns on when there is an error in the settings.
R905C to
R905F
Not used -