Panasonic fp2/fp2sh - Page 295

11-27
FP2/FP2SH/FP10SH
Address
Name
Description
R9090
MEWNET-W/-P
PC link
operation mode
relay
[for PC link 1
(W/P)] (*Note)
Unit
No.1
Turns on when unit No. 1 is in the RUN mode.
Turns off when unit No. 1 is in the PROG. mode.
R9091
Unit
No.2
Turns on when unit No. 2 is in the RUN mode.
Turns off when unit No. 2 is in the PROG. mode.
R9092
Unit
No.3
Turns on when unit No. 3 is in the RUN mode.
Turns off when unit No. 3 is in the PROG. mode.
R9093
Unit
No.4
Turns on when unit No. 4 is in the RUN mode.
Turns off when unit No. 4 is in the PROG. mode.
R9094
Unit
No.5
Turns on when unit No. 5 is in the RUN mode.
Turns off when unit No. 5 is in the PROG. mode.
R9095
Unit
No.6
Turns on when unit No. 6 is in the RUN mode.
Turns off when unit No. 6 is in the PROG. mode.
R9096
Unit
No.7
Turns on when unit No. 7 is in the RUN mode.
Turns off when unit No. 7 is in the PROG. mode.
R9097
Unit
No.8
Turns on when unit No. 8 is in the RUN mode.
Turns off when unit No. 8 is in the PROG. mode.
R9098
Unit
No.9
Turns on when unit No. 9 is in the RUN mode.
Turns off when unit No. 9 is in the PROG. mode.
R9099
Unit
No.10
Turns on when unit No. 10 is in the RUN mode.
Turns off when unit No. 10 is in the PROG. mode.
R909A
Unit
No.11
Turns on when unit No. 11 is in the RUN mode.
Turns off when unit No. 11 is in the PROG. mode.
R909B
Unit
No.12
Turns on when unit No. 12 is in the RUN mode.
Turns off when unit No. 12 is in the PROG. mode.
R909C
Unit
No.13
Turns on when unit No. 13 is in the RUN mode.
Turns off when unit No. 13 is in the PROG. mode.
R909D
Unit
No.14
Turns on when unit No. 14 is in the RUN mode.
Turns off when unit No. 14 is in the PROG. mode.
R909E
Unit
No.15
Turns on when unit No. 15 is in the RUN mode.
Turns off when unit No. 15 is in the PROG. mode.
R909F
Unit
No.16
Turns on when unit No. 16 is in the RUN mode.
Turns off when unit No. 16 is in the PROG. mode.
Note) When the system registers 46=K0, PC link 0 for the link unit with a smaller slot No. and PC link 1
for one with a larger slot No.
When the system registers 46=K1, PC link 1 for the link unit with a smaller slot No. and PC link 0
for one with a larger slot No.