Automatic Operation (Synchronous Control)
8-20
Editing of the cam table
Edit the cam table data that was created.
Set the following items for each section set:
• Starting phase (%)
• Displacement (%)
• Cam curve
The cam curve changes according to the settings.
• The termination phase cannot be set. The termination phase will be
changed automatically if the staring phase is changed.
• Do not make a radical displacement change of set cam curves. There is a
possibility that the motor cannot keep up with the output in the case of
rapid displacement.
• Similarly, make settings that a phase of 0% and that of 100% are the same in
displacement.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...
