4.4
ELECTRONIC FUEL INJECTION
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
Digital Wrench™ - Diagnostic Connector
Located under the dash connected to a sealed plug.
Digital Wrench™ - Down
load Website
Located at:
www.polaris.diagsys.com
Download Digital Wrench™ Updates:
IMPORTANT: For the most re
cent information on
Digital Wrench™
software and update downloads
please visit the website:
www.polaris.diagsys.com
Service Notes
• For more convenient and accurate testing of EFI
components, it is recommended dealers utilize the
Digital Wrench™ Diagnostic Software (dealer
only), or testing may be done manually using the
procedures provided.
• 80% of all EF
I problems are caused by wiring
harness connections.
• For the purpose of troubleshooting difficult running
issu
es, a known-good ECU from another
RANGER RZR 800 EFI of the same model and
year may be used without damaging system or
engine components.
• Never attempt to service any fuel system
comp
onent while engine is running or ignition
switch is "on."
• Cleanliness is essential and
must be maintained at
all times when servicing or working on the EFI
system. Dirt, even in small quantities, can cause
significant problems.
• Do not use compressed air if the syst
em is open.
Cover any parts removed and wrap any open
joints with plastic if they will remain open for any
length of time. New parts should be removed from
their protective packaging just prior to installation.
• Clean any connector before opening to prevent dirt
from entering the syst
em.
• Although every precaution has been taken to
pr
event water intrusion failure, avoid direct water
or spray contact with system components.
• Do not disconnect or reconnect the wiring harness
conn
ector to the control unit or any individual
components with the ignition "on." This can send a
damaging voltage spike through the ECU.
• Do not allow the battery cables to touch opposing
te
rminals. When connecting battery cables attach
the positive (red) cable to positive (+) battery
terminal first, followed by negative (black) cable to
negative (-) battery terminal.
• Never start the engine when the cables are loose
or
poorly connected to the battery terminals.
• Never disconnect battery while engine is running.
• Never use a battery boost-pack to start the engine.
• Do not charge battery with key switch "on."
• Always disconnect negative (-) battery cable lead
b
efore charging battery.
• Always unplug ECU from the wire harness before
pe
rforming any welding on the unit.
To Next Page
Loading...
Need help?
General
