6.29
CLUTCHING
6
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
Clutch Assembly
1. Install a new bearing onto the clutch shaft using an
arbor press. Once bearing is fully seated, install a
new snap ring.
2. Install the shaft and bearing assembly into the outer
sheave.
NOTE: Press only on the outer race of the bearing
du
ring installation to prevent damaging the bearing.
3. Line up the “X” on the moveable sheave with the “X”
o
n the stationary sheave or use the marks previously
used. Put the sheaves together.
4. Install the roller (A) onto the roller pin (B) on both
sides.
To Next Page
Loading...
