Polaris 2013 RANGER RZR S - Starter Solenoid Bench Test; Starter Solenoid Operation

10.37
ELECTRICAL
10
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
Starter Solenoid Bench Test
Test the start solenoid by powering the solenoid using
battery voltage for a
maximum of 5 seconds. With the
solenoid energized, resistance should read about 0 - 0.5
W
between terminals (A) and (B). If resistance measurement
is out of specification, replace the starter solenoid.
Starter Solenoid Operation
To energize the Starter Solenoid the following must occur:
• The brake must be applied to provide a ground
path via the Orange wire.
• The key switch must be turned to the “start”
position to provide 12V power via the Green /
White wire.
• Once the pull-in coil is energized, the solenoid
provides a current path for 12V power to reach the
starter motor.
A
B
Energize
Here