7.44
FINAL DRIVE
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
When the clutch gear is unlocked the rear drive shafts are
dependent on the differential allowing tighter turns. When
it’s locked it becomes a solid rear axle increasing traction.
Gearcase Removal
1. Drain the fluid from the rear gearcase and remove the
rear drive shafts from each side of the rear gearcase.
See “REAR DRIVE SHAFT” on page 7.29
2. Remove the exhaust pipe and exhaust silencer to
allow for gearc
ase removal.
3. Remove upper A-arm bolts, lower rear A-arm bolts
and
suspension plate. NOTE: If accessory rear rack
cab frame is installed, remove the (4) bolts
retaining it to the suspension plate (see photo).
4. Remove the (2) rear gearcase mount bracket
fa
steners and mount bolt and remove bracket from
vehicle.
IRS Axle
Clutch Gear
Unlocked
Locked Mode
Unlocked Mode
Axle Shaft
Clutch Gear
Locked
Axle Shaft
Axle Shaft
Axle Shaft
Remove
Remove
Suspension
Plate
Remove
To Next Page
Loading...
