Polaris 2013 RANGER RZR S User Manual

5.54
BODY / STEERING / SUSPENSION
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
23. Inspect the valve shims for kinks, waves, pits or
foreign material.
24. Inspect the piston wear ban
d and replace if damaged
or worn.
25. Replace the piston O-ring (if equipped).
26. Make note of the positioning of the piston for proper
a
ssembly. The compression side of the piston has
larger ports with raised edges.
27. Remove and replace jounce bumper from shock rod.
FOX™ PODIUM ‘Piggyback’
Body and Reservoir Service
Disassembly
1. Use the appropriate shock body holding tool (PS-
4
5281-A) to properly secure the shock body
assembly into a vice for service.
2. Heat the body cap and reservoir base with a small
h
eating torch to break the adhesive bond between cap
and shock body.
3. Use a spanner or strap wrench to remove the shock
b
ody tube and reservoir from the body cap.
4. Clean the adhesive out of the threads with a wire
bru
sh and/or a small pick.
5. Apply Loctite® 7649™ primer to shock body and
rese
rvoir threads and let dry for reassembly.
6. Remove the low speed compression cap using a #10
Tor
x bit driver.
7. Use a 5/8" socket to remove the LSC / DSC
c
ompression control.
8. Replace the O-rings on the low speed compression
pist
on.
9. Inspect the LSC / DSC blow out control with low
pre
ssure compressed air and replace O-rings.
10. Replace the internal and external O-rings on the
rese
rvoir body. Be sure O-rings are lubricated with
shock oil before and after installation.
Assembly
1. Apply Loctite® 620™ on primed shock body and
rese
rvoir threads.
2. Use a spanner or strap wrench to torque the reservoir
bod
y to specification.
3. Remove excess Loctite® 620
™ from body surface.
4. Install and torque the DSC and LSC to specification.
WARNING
The following procedure involves the use of an
open flame. Perform this procedure in a well-
ventilated area, away from gasoline or other
flammable materials. Be sure the area to be
flame treated is clean and free of gasoline
or flammable residue.
Do not flame treat components that are installed
on the vehicle. Remove the component from the
vehicle before flame treating.
= T
Reservoir Body: 30 ft-lbs (40 Nm)
Shock Body: 50 ft-lbs (40 Nm)
= T
DSC: 35 ft-lbs (47 Nm)
LSC: 14 ft-lbs (19 Nm)
PRELIMINARY VERSION

Polaris 2013 RANGER RZR S Specifications

General

Brand	Polaris
Model	2013 RANGER RZR S
Category	Offroad Vehicle
Language	English