7.12
FINAL DRIVE
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
6. Remove the fasteners retaining the plastic skid plate
and remove the skid plate from the vehicle.
7. Remove the propshaft from the vehicle.
8. Reverse removal steps to r
einstall propshaft. Use a
NEW Roll Pin (Spring Pin) upon reassembly.
Removal / Installation (RZR 4)
1. Locate the propshaft roll pin and use the Roll Pin
Removal Tool (PN 2872608) to remove the roll pin.
NOTE: Front wheel can be removed to gain better
a
ccess to the propshaft roll pin.
2. Remove both front seats.
3. Remove the gear selector cap.
4. Remove the retaining screw and the gear selector
h
andle.
5. Remove the fasteners retaining the center console to
acce
ss the propshaft support bearing.
6. Remove the (2) bolts and washers retaining the
su
pport bearing.
7. Slide the rear portion of the propshaft back to separate
it fro
m the front portion.
8. Slide the front portion of the propshaft back and away
f
rom the front gearcase to remove it.
Roll Pin Removal Tool (PN 2872608)
Torx Screw
Torx Screws
Cap
Screws
Torx Screws
To Next Page
Loading...
Need help?
General
