Polaris 2013 RANGER RZR S User Manual

5.59
BODY / STEERING / SUSPENSION
5
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
39. Remove oil residue from above the IFP with a clean
shop towel.
40. Lubricate and install a new pellet into the reservoir
cap.
41. Install the pellet retainer.
42. Lubricate the reservoir cap O-ring.
43. Install and depress the reservoir cap past the retaining
r
ing groove.
44. Install the reservoir cap retaining ring.
45. Use the nitrogen charging needle (7052069-A) and
safely cha
rge the reservoir to the recommended
pressure.
46. Stroke the shock through its travel and adjust the
ex
ternal adjusters to ensure they are functioning
properly
.
47. Use a rubber mallet to fully seat the bearing cap into
position.
48. Use a dead blow hammer to fully seat a new nylon ball
i
nto the reservoir cap.
49. Install suspension spring(s) and reset preload to
fac
tory settings.
50. Adjust external adjusters to the factory settings
51. Install shock onto the vehicle and torque fasteners to
specification.
WARNING
CHARGE THE SHOCK USING NITROGEN
GAS ONLY. DO NOT FILL WITH ANY OTHER
GASES. Doing so compromises the
performance of the shock and may be
EXTREMELY DANGEROUS!
Nitrogen Pressure (Front and Rear):
200 psi (1379 kPa) +/- 5%
PRELIMINARY VERSION

Polaris 2013 RANGER RZR S Specifications

General

Brand	Polaris
Model	2013 RANGER RZR S
Category	Offroad Vehicle
Language	English